Filter
Top Products
Teledyne API - Model 200EH/EM Operation Manual Operating Instructions
105
6.12.1. SETTING THE GAS MEASUREMENT MODE
In its standard operating mode the M200EH/EM measures NO, NO
2
and NO
x
. It can be set to measure only NO
or Only NOX s can be set to measure NO or NO
x
. To select one of these three measurement modes, press:
SETUP X.X 1 ) MEASURE_MODE=NOX-NO
PREV NEXT JUMP EDIT PRNT EXIT
EXI
T
ignores the new
setting.
ENTR accepts the
new setting.
SAMPLE ENTER SETUP PASS : 818
8 1 8 ENTR EXIT
SAMPLE A1:NXCNC1=100PPM NOX=XXX.X
< TST TST > CAL SETUP
SETUP X.X MEASURE MODE: NOX-NO
PREV ENTR EXIT
SETUP X.X MEASURE MODE: NOX
PREV NEXT ENTR EXIT
SETUP X.X MEASURE MODE: NO
NEXT ENTR EXIT
NOX-NO mode is the
default mode for the
M200EH/EM
Press the PREV
and NEXT buttons
to move back and
forth between gas
modes
SETUP X.X
PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SETUP X.X
SECONDARY SETUP MENU
COMM VARS DIAG EXIT
SETUP X.X 0 ) DAS_HOLD_OFF=15 minutes
NEXT JUMP EDIT PRNT EXIT
04521C (DCN5731)