Filter
Top Products
Chapter 2 Tutorial
116 Chapter 2 Tutorial
Effect settings
On the SU700, you can assign any desired effect type to each of the three buttons
[EFFECT 1]-[EFFECT 3], and then specify how each of the three effects will be ap-
plied to each track.
Procedure
●
Select the effect type and the depth of the effect
1.
Press the EFFECT SETUP/[SETUP 1] (or [SETUP 2] or [SETUP 3]) button.
2.
The display will indicate the currently selected effect type.
Rotate the data dial to select the desired effect type.
NOTE:
For details on the available effect types and what they do, refer to “Effect type list” (
→
p.333).
▼ There are two categories of effect, distinguished by how they are connected; Sys-
tem effects and Insertion effects (→ p.189 to 191).
▼ In the case of a System effect, brackets (
) will be displayed in the meter display of
all tracks. Rotate the knobs of one or more tracks to adjust the depth of the effect for
each track. You can strike a pad to hear the sound with the effect applied.
NOTE:
• The depth at which the effect is applied to each track can also be specified when you
press the EFFECT/[EFFECT 1]-[EFFECT 3] button. In this case, the display will indicate
the value that was set.
• If you have selected an effect such as delay that creates cyclic change, the NOTE
area of the display will indicate “RESOLUTION=.” The cycle (resolution) at which
the effect changes will be controlled in units of the note value that you specify here.
We will be making this “RESOLUTION=” setting in step 6 of this procedure.