Filter
Top Products
Chapter 10 Jobs 261
CHAPTER 10
Increment by
thousands of frames
Use to change
the increment
Increment by
tens of frames
3.
Press the and to select the adjustment increment you want to use (the
number of high-order digits you want to operate on).
This setting determines the increment at which the value changes when you turn the
dial. For example, you can opt to adjust by single units (all eight digits), by incre-
ments of 10 (the first seven digits only), by increments of 100 (the first six digits
only), and so on up to increments of 10,000,000 (the first digit only). Press
to in-
crease the increment, and
to decrease it. The selected digits flash on the screen.
NOTE:
Although the dial will only affect the high-order digits you have selected, you will see
the lower digits changing too. This is because the lower digits are adjusted as necessary
to move to the next zero-cross point on the waveform.
4.
Turn the dial to adjust the value.
5.
Continue making adjustments to start and stop values as necessary. You can switch
between START POINT and END POINT screens simply by pressing the correspond-
ing buttons on the left of the job grid. (You do not need to press the SAMPLE selec-
tor again.) You can switch to different tracks by using the bank selectors and the
pads. You can switch the increment range at any time by pressing the cursor keys.
6.
When you are finished making changes, press [OK] or [CANCEL] to quit the job and
return to the main screen.