Filter
Top Products
Chapter 9 Editing Functions 219
CHAPTER 9
Parameters
The first five parameters are different for each effect. For an explanation of each ef-
fect and its parameters, to the effect listings starting on page 333.
The subsequent parameters set up the output from the effect block itself, and are
therefore the same regardless of the selected effect. These parameters are as follows.
Refer also to the diagram below.
LEVEL Sets the output level from the effect block. (See illustration, page 188.)
Range: 000 to 127
Default: 100
PAN Sets the pan (positioning) for the output from the effect block. (See illus-
tration, page 188.)
Range: L64,...,L01, C, R01,...,R63
Default: C (center)
EF2 SEND This parameter is available only for block 1 (only under the [SETUP␣ 1]
function). The parameter sets the level for the signal feed from block 1
into block 2. (See illustration, page 188.)
Range: 000 to 127
Default: 000
EF3 SEND This parameter is available only for blocks 1 and 2 (only under the
[SETUP 1] and [SETUP 2] functions. The parameter sets the level for
the signal feed from the corresponding block into block 3. (See illustra-
tion, page 188.)
Range: 000 to 127
Default: 000