Filter
Top Products
Chapter 10 Jobs 283
CHAPTER 10
7.
Press [OK] to execute the load and return to the main screen.
▼ The SU700 clears all of its internal data and begins loading all of the data from the
selected volume. The screen displays LOADING... to indicate that loading is in
progress. When loading is finished, the main screen appears. The screen displays
the lowest-numbered nonempty song of the new volume (or Song 1, if all loaded
songs are empty).
●
If you are loading a volume stored on multiple floppy disks, you must insert each
disk in order, then wait for the prompt to insert the next disk
INSERT FD xx
where xx indicates the number of the disk within the set (02, 03, ..., 99). If you insert
a disk in the wrong order, the screen will prompt you again. If you like, you can
cancel the load between disks by pressing the [CANCEL]. This will terminate the job
and return you to the main screen.
●
If the internal memory becomes full while loading is in progress, the SU700 displays
the message MEMORY FULL, and the load is cancelled.
<LOAD SAMPLE>
This job loads a single sample (the waveform data and the start-point and end-point
settings) from the selected disk volume into the selected track of the current song.
The SU700 sample must have been previously saved to disk from the SU700 using the
SAVE VOLUME job (→ p.287).
This operation will overwrite any sample data existing in the destination track.
Procedure
1.
If you are going to load from floppy disk, insert the disk containing the sample you
need. If you are loading from an external SCSI disk, be sure that the SCSI drive is
correctly mounted (→ p.32), and that the correct disk is inserted (if applicable).
●
You cannot load a single sample from a volume stored on multiple floppy disks.
When reloading from multiple floppy disks, you must load the entire volume.
2.
Press DISK | LOAD to enter this job.
3.
Turn the dial as necessary to select LOAD SAMPLE, and then press [OK].
▼ The screen displays SELECT TRACK, prompting you to select the destination track.