Filter
Top Products
Chapter 7 Effects
188 Chapter 7 Effects
7.3 Effect Blocks
The SU700 provides three effect blocks, with a separate effect assigned to each block.
An effect is applied by passing the signal output from the tracks through the corre-
sponding effect block. You might want to note that the SU700 will never pass the
entire signal through the block; some part of the signal will always bypass the block,
as illustrated below.
Effect Block
The three blocks are interconnected. Blocks 1, 2, and 3 all transmit their signals di-
rectly to the standard STEREO OUT jacks (and phone jacks), but you are also free to
pass output from Block 1 through Blocks 2 and 3, and output from Block 2 through
Block 3.
Specifically, you can set the following interconnection levels (“send” levels):
● Level of Block 1 signal going to Block 2. (Block 1’s EF2SEND parameter)
● Level of Block 1 signal going to Block 3. (Block 1’s EF3SEND parameter)
● Level of Block 2 signal going to Block 3. (Block 3’s EF3SEND parameter)
You set these parameters using the [EFFECT SETUP] buttons. The following illus-
trates the connection. For more information, refer to page 214.
EF2 SEND
PANLEVEL
EF3 SEND
EFFECT 1
PANLEVEL
PANLEVEL
EF3 SEND
EFFECT 3
EFFECT 2
output
Track Output
OutTrack Output