Filter
Top Products
Chapter 2 Tutorial 67
CHAPTER 2
Use the cursor buttons ( , ) to make the “beat” field of the location blink, ro-
tate the dial to set it to “1,” and press the [OK] button.
●
If there is more than one note event, use to move to the previous event, to
the next event, or
to the first event.
●
In addition to the location of a note event, you can also modify its velocity and gate
time.
2.3.4 Setting Up The Second COMPOSED LOOP track (“CL2”)
■ Sampling
As you did for the LOOP 1 track, sample Track 82 from the included audio CD to
COMPOSED LOOP 2 (subsequently referred to as CL2).
●
Set the sampling grade to “22K 8BIT MONO L.”
■ Setting the loop length
Using the same procedure as you did for the LOOP 2 track, set the sample of the CL2
track to “LOOP LENGTH=016.”
■ Recording the Loop Phrase
The sample for the CL2 track will be in a loop that is 16 quarter-note beats long (four
measures), and will play for the final three beats of the loop, starting at beat 004:2
and ending at 005:1, as shown below.
Record this phrase using the same method you used to record on track CL1. Start the
sequencer in REC mode, press the pad when the location indicator gets to 004:2, hold
it for three beats, and release it just as the indicator is about to change to 005:1.
CL2 sample