Filter
Top Products
Chapter 2 Tutorial
44 Chapter 2 Tutorial
2.
To adjust the level on any track, turn the track’s knob. You can listen to the re-
sult by hitting the track’s pad.
■ Adjusting the Other Parameters
Now try adjusting some of the other parameters in the same way. First press the but-
ton on the Knob Function panel, and then turn the knobs on each track while at the
same time hitting the pad so that you can hear the sound. Try working will all param-
eters, starting with SOUND/[LEVEL] and ending with EFFECT/[EFFECT␣ 3].
NOTE:
• Not all knob settings are supported on all tracks. If a setting is not supported, the dis-
play will show “---” in place of a numerical value.
• You will not be able to hear the results of GROOVE adjustments while the sequencer
is stopped—since the groove feature operates only while the song is playing. You
should adjust the GROOVE-group settings after you start song playback.
• The EFFECT group settings ([EFFECT 1], [EFFECT 2], and [EFFECT 3] control the signal
levels to the three effect blocks. The effects themselves are selected using the Editing
Panel’s [EFFECT SETUP] buttons ([SETUP 1], [SETUP 2], [SETUP 3]). For information
about the effects implementation, see Chapter 7, “Effects,” on page 185.
Rotate the knob for the
LOOP1 track to adjust
the volume