Filter
Top Products
Chapter 10 Jobs 305
CHAPTER 10
Receive-channel setting
Note number
Transmit channel setting
(Note) = Assigns the note number used when transmitting MIDI messages gen-
erated by the track. This setting lets you use each track to drive a given
note on an external device. (Typically, you would use this setting to ar-
range pads so that they drive different drum sounds in an external a
drum kit.) Note that this setting is effective only for MIDI transmission,
and not for reception. The note value is sent over the track’s Transmit
channel. The setting is meaningless if the track’s TRANS setting is OFF.
Procedure
Be sure that you have selected the song whose MIDI values you want to set.
1.
Press SYSTEM | MIDI to enter this job. Then turn the dial as necessary to select
CHANNELS, and press [OK].
▼ Notice that you can now move among the three parameters by pressing the
and buttons.
2.
Set the parameter values for each track you are interested in.
▼ Use bank selectors and track pads as necessary to select each track.
▼ Use the
and to select the parameter you wish to set.
▼ Use the dial to set the parameter value.
NOTE:
For the TRANS channel-number setting, the job will not allow you to select numbers that
are already in use on other channels.
3.
When you are finished making settings, press [OK] to return to the main screen, or
[CANCEL] to move back one level in the job.
Setup page 2Setup page 1