Filter
Top Products
Chapter 2 Tutorial 117
CHAPTER 2
Indicates the depth at which the 1DELAY
effect is applied to each track
Resolution at which
the effect will change
▼ Example display when a system effect (1DELAY) has been selected
▼ In the case of an Insertion effect, brackets ( ) will be displayed only in the meter
display of the tracks to which the effect is connected. The effect will apply only to
the sample of the tracks that you selected by pressing their pad. The effect depth is
adjusted by the MASTER track knob. It cannot be adjusted separately for each track
(sample). You can strike a pad to hear the sound processed by the effect.
NOTE:
• The depth at which the effect is applied to each selected track can also be specified
using the MASTER knob when you press the EFFECT group [EFFECT 1]-[EFFECT 3]
button. In this case, the display will indicate the value that was set.
• An insertion effect can be applied to the AUDIO IN track.
• If you have selected an effect such as flanger that creates cyclic change, the NOTE
area of the display will indicate “RESOLUTION=.” The cycle (resolution) at which
the effect changes will be controlled in units of the note value you specify here.
We will be making this “RESOLUTION=” setting in step 6 of this procedure.
▼ Example display when an insertion effect (AUTOSYN) has been selected
Resolution at which the
effect will change
Tracks to which the AUTOSYN
effect will be applied
The depth at which
the AUTOSYN
effect is applied to
each track