Filter
Top Products
Chapter 9 Editing Functions
214 Chapter 9 Editing Functions
9.1 Overview
You use the editing function panel to perform the following tasks.
●
Cancel an effect.
Instantly switch off operation of an effect.
●
Set up each effect block.
Select the effect type for each block, and set the effect’s parameters.
●
Reset knob function values.
Reset all values for the selected track to their defaults.
●
Delete note events.
Delete note events over selected range on selected COMPOSED LOOP or FREE
track.
●
Assist in name editing.
Insert or remove a character (when editing a name).
9.2 EFFECT SETUP Group
You use this group to set up the effect blocks, and to instantly switch off the effect on
any block. (For general information about the SU700’s effects implementation, refer
to Chapter 7, “Effects,” on page 185.)
CLEAR 1, CLEAR 2, and CLEAR 3
Use these buttons when you wish to switch off the sound of an effect during play-
back. Pressing any of these buttons and then the [OK] button will instantly cancel all
signal flow to the corresponding effect block, immediately shutting off the effect.
These functions can be accessed only while the sequencer is in PLAY or PLAY
STANDBY. You can not record CLEAR operations directly into your song.
Remember that like all control actions carried out with the sequencer in PLAY or
PLAY STANDBY, the CLEAR operation will cause the current environment to deviate
from the song’s true environment. Knob and scene actions recorded later in the song
may cause the effect to become audible again.
NOTE:
Although you cannot record CLEAR operations directly into your song, you can record
them indirectly by storing the results into a scene, and then recording the appropriate
scene-change event into your song.