Filter
Top Products
Chapter 10 Jobs
230 Chapter 10 Jobs
SONG | INIT
Use to: Initialize the current song. This job deletes all song data stored in the
specified song number. The following information is deleted or reset: all
samples, all sequence data, all knob data, all scene content, all marker set-
tings, MTC offset, track settings, and MIDI settings.
Procedure
1.
Press SONG | INIT to enter this job.
▼ The screen displays INIT SONG xx, where xx is the song number of the song to be
initialized (deleted).
2.
Turn the dial as necessary to select the song you wish to delete. Then press [OK] to
execute initialization and return to the main screen.
▼ The SU700 initializes the selected song.
SONG | MTC OFFSET
Use to: Set the MTC (MIDI Time Code) offset for the selected song. This setting
allows you to set a timing offset in cases where you are synchronizing song
playback with an externally supplied timecode signal-such as signals re-
corded on videotape or multitrack tape.
●
This setting is effective only if you are using external MIDI time code to synchro-
nize SU700 song play. In particular, the setting is effective only if the SYNC param-
eter (in the SYSTEM | MIDI job) is set to MTC SLAVE (→ p.303).
Procedure
1.
Press SONG | MTC OFFSET to enter this job.
▼ The screen displays the currently set offset. The default is 00H, 00M, 00S, 00M,
where H, M, S, and F refer to hours, minutes, seconds, and frames, respectively.
The hour value is flashing.
2.
Press or to move the cursor to the value you wish to enter (hours, minutes,
seconds, or frames). The value at that position flashes to indicate that it is selected.
3.
Turn the dial as necessary to set the value.
4.
Repeat steps 2 and 3 as necessary to enter all values.
5.
When you are finished, press [OK] or [CANCEL] to return to the main screen.