Filter
Top Products
Chapter 8 Knob Functions 207
CHAPTER 8
Original track output
SPEED [LFO SPEED]
Range: 000 to 127
Default: 025
Works on: Sample tracks
Adjusts the frequency of the LFO wave. Higher values produce faster modulation. A
setting of 000 switches modulation off.
AMP [LFO AMP DPTH]
Range: 000 to 127
Default: 000
Works on: Sample tracks
Sets the amount by which the LFO modulates the track’s output volume. A setting of
000 switches volume modulation off, while higher values increase the amount of the
applied modulation.
NOTE:
•
The function name, LFO AMP DPTH (for LFO amplitude depth), refers to the degree
(the depth) by which the modulation waveform acts as an offset on the track
waveform’s amplitude.
•
This function cannot supply a saw-up modulation waveform. If you set the LFO wave
to SAW UP (in the TRACK SET | SETUP job) this function will supply a saw-down
modulation wave. (
→
p.240)
LFO waveform
RESOLUTING LEVEL:
ORIGINAL LEVEL:
Time
SPEED = 00 (no modulation)
SPEED = 64
SPEED = 127
(assuming that LFO WAVE = SQUARE)