Filter
Top Products
Chapter 9 Editing Functions 217
CHAPTER 9
If insertion effect:
HINT:
Regardless of other settings, you can always tell whether or not an effect is an insertion
effect by looking the meter brackets for the MASTER track. If the brackets are off, the ef-
fect is an insertion effect; if the brackets are visible, the effect is a system effect.
2.
Turn the dial to select the effect that you wish to assign to the block (so that the ef-
fect name appears on the screen).
▼ The new selection becomes effective immediately. You will immediately hear the
sound produced by the newly selected effect. Note that you can use the MASTER-
track knob (if insertion effect) or the other knobs (if system effect) to adjust the effect
levels.
3.
If you have selected an insertion effect, proceed as follows. Otherwise, jump to Step 4.
Connection Settings for Insertion Effect:
Use the bank selectors and pads to select the tracks that you want to connect to this ef-
fect. (You can also set or revise the connections at any of the subsequent parameter-
settings pages.) To switch connection on, press the pad so that the track’s brackets
become visible. To switch connection OFF, press the pad so that the brackets disap-
pear. You can switch connection ON or OFF for all tracks other than the MASTER
track.
EXAMPLE:
ON OFF ON ON OFF ON OFF OFF ON ON OFF
FLANGER is an insertion effect. Only tracks whose
brackets are visible will connect to the selected effect block.
Name of effect.
Current resolution.
(Cannot be changed from this screen.)
Brackets indicate tracks (in bank 2) for
which this effect is currently set ON.