Filter
Top Products
Chapter 10 Jobs
286 Chapter 10 Jobs
5.
Press [OK].
▼ The screen displays DRIVE=
drive_name
.
6.
Turn the dial as necessary to select the disk (partition) you wish to import from.
●
To import from floppy disk, select DRIVE=FDD. (This selection is forced if you have
not mounted a SCSI drive.)
●
To import from a SCSI disk, select DRIVE=SCSI (if the disk is unpartitioned) or
DRIVE=SCSI P
x
(where
x
is the partition number).
7.
After selecting the drive, press [OK].
▼ The screen shows the volume name of most recently selected volume on the se-
lected drive: VOLUME=
volume name
. (If you are importing from floppy disk, then
the name is always FD VOLUM.)
●
If you have selected FDD or a removable-disk SCSI device and no disk is present,
the screen will display NO DISK. If you have selected a disk that does not contain
any volumes, the screen will display VOLUME=(NONE). If you are using a foreign
disk with an unsupported format, the screen displays UNKNOWN FORMAT. In any
of these cases, press [CANCEL] as necessary to return to a previous step or to escape
from the job.
8.
If you are importing from a SCSI drive, turn the dial as necessary to select the volume
containing the sample that you want. (Remember that floppy disks hold a single vol-
ume only; if you are importing from floppy disk, therefore, you will not be able to
change the selection).
▼ The screen displays SAMPLE=
sample_name
, where
sample_name
is the name of
one of the samples in the selected volume.
●
If the volume on disk contains no samples, the screen displays NO SAMPLES. Press
[CANCEL] as necessary to return to a previous step or to escape from the job.
9.
Turn the dial as necessary to select the sample that you wish to import, by its
filename.