Filter
Top Products
Chapter 2 Tutorial
68 Chapter 2 Tutorial
2.3.5 Setting Up The Third COMPOSED LOOP track (“CL3”)
■ Sampling
Using the same procedure as you did for the LOOP 1 track, sample Track 83 of the
included audio CD to the COMPOSED LOOP 3 track (hereafter referred to as “CL3”).
●
Set the sampling grade to “22K 8BIT MONO L.”
■ Setting the Loop Length
Using the same procedure as you did for the LOOP 2 track, set the CL3 track to
“LOOP LENGTH=016.”
■ Recording the Loop Phrase
Now we’ll record the sample to the CL3 track of the sequencer.
The CL3 track is 16 quarter-notes long (four measures), and we will play the sample
over the first three beats of the loop, beats 001:1 to 001:4, as shown below.
Record this phrase using the same method you used to record on the other CL tracks.
Start the sequencer in REC mode, press the CL3 pad when the location indicator
reaches 001:1, hold it for three beats, and release it just as the indicator reaches
001:4.
2.3.6 Setting Up The Fourth COMPOSED LOOP track (“CL4”)
■ Sampling
Using the same procedure as for the LOOP 1 track, sample Track 84 from the in-
cluded audio CD to the COMPOSED LOOP 4 track (subsequently referred to as
“CL4”).
●
Set the sampling grade to “22K 8BIT MONO L.”
■ Setting the Loop Length
Using the same procedure as you did for the LOOP 2 track, set the CL4 track to
“LOOP LENGTH=032.”
CL3 sample