Filter
Top Products
Chapter 2 Tutorial 65
CHAPTER 2
●
Undo is valid only for the immediately-previous recording operation (stop → re-
cording → stop). When you perform the next recording operation (stop → record-
ing → stop), it will not be possible to Undo any prior recording operations.
● To delete a sample that was recorded by mistake
Put the sequencer in recording mode (
+ ), and at the location where the sample
you wish to delete is played, hold down the JOB group [NOTE DEL] button and
press the CL1 pad to delete any note-on data for the CL1 sample that occurs in that
area. Since the CL1 track is a loop, the samples deleted from that area will disappear
from the entire song.
●
Since this will delete CL1 note-on data, performing the above operation is enough
to stop the sample from playing.
Alternatively, you can set the recording mode to “REPLACE,” and then re-record over
again while erasing the previously-recorded data.
Redo
Undo
disappears
CL1 sample