Filter
Top Products
CHAPTER 1
Chapter 1 SU700 Components, Connections, and Startup 31
R L/MONO
STEREO OUT
R L
ANALOG INPUT
Using the AIEB1-board outputs
If you have installed the optional AIEB1 board (input/output expansion
board), you will be able to use the board’s assignable and digital/optical
outputs. Note the following points.
• Under factory defaults, the output goes to the STEREO OUT jacks.
• The signal to the STEREO OUT jacks is also directed to the DIGITAL
OUT and OPTICAL OUT connectors.
• You can use the TRACK SET | SETUP job’s OUTPUT TO parameter to
direct output from selected sample tracks to selected assignable output
jacks. For each track, you can decide whether to output to a single output
jack or to a pair of output jacks.
• Note that that when you direct a track to an assignable output:
(a) The track is directed to the selected jack(s) only. It does not flow to
the STEREO OUT or digital/optical outputs.
(b) The track output does not pass through the effect blocks.
For information about setting up the OUTPUT TO parameter, see page 239.