Filter
Top Products
Checklists and job aids
Upgrade an S8100’s R10+ software using a CD
S8100 Installation and Upgrades 13
November 2003
Upgrade steps
Step Details
1 For a direct connection between the
technician’s laptop and the S8100’s service
port:
LT – Change the laptop’s IP address to
192.11.13.5
a Right-click the 'Network Neighborhood' {My
Network Places} icon on the laptop’s desktop, and
select Properties.
b {Right-click ‘PCMIA Ethernet Connection’ (or
Local Area Connection), and select Properties.}
c Highlight the TCP/IP icon from the popup window,
and select Properties. Check the ‘Specify an IP
address’ {‘Use the following IP address’} radio
button.
d Enter 192.11.13.5 in the IP address field and
255.255.255.252 in the subnet mask field, and
click OK to close the popup windows.
2 LT-IE – Disable proxy servers on Internet
Explorer.
a Open Internet Explorer and select Tools, Internet
Options, the Connections tab, and LAN Settings.
b Uncheck the ‘Use a proxy server’ radio button and
click OK to close the popup windows.
3 Connect the laptop to the service jack on the
front of the S8100’s Processor board.
a Connect a cable from the laptop’s PCMCIA
Ethernet card to an RJ45 coupler.
b Connect a cross-over (flip) cable from the coupler
to the TN2314’s RJ45 jack.
4 LT-IE – Connect to the S8100 server via the
web interface.
Open Internet Explorer on the laptop, and enter
192.11.13.6 in the URL address bar to connect to the
processor.
5 LT-IE – Open the S8100’s desktop.
Note: Terminal server client and terminal
services Active X must be installed on the
laptop. The easiest way to do this is to
upgrade your Windows 95 laptop’s browser to
Internet Explorer version 5.5 or higher.
a Click ‘Administer System’ and log in using
lucent3 for login and password. A domain is not
required. Select 'continue' at license agreement
window.
b Select ‘Login to 192’ under Remote Control –
Terminal Services.
c If a VBScript error message appears, click OK.
d Click the Connect button (leave the Server field
blank).
e If a VBScript message appears, click OK (you can
resize the Terminal Services screen to full size by
pressing ctlr-alt-Pause). A log-in window opens.
f Log in using lucent3. After logging in, the
S8100’s Windows 2000 desktop is displayed.
6 SDT – Open a bash shell window. Click Start → Run → bash.
7 BS – Open a LAC window. Execute telnet 127.1.and log in using lucent3.