Filter
Top Products
JInstall and cable a CMC1 cabinet
Unpack and inspect
S8100 Installation and Upgrades 345
November 2003
Figure 54: Equipment packed with a single CMC1
Table 59, Comcodes for equipment used with CMC1, on page 346 lists the comcodes for equipment used
with the CMC1. If “Optional” is marked with an "×", the equipment may be unnecessary, depending on
the site’s configuration.
Figure notes
1 Left panel (also acts as wall-mounting
template and as floor-mounting pedestal)
2 CMC1 cabinet
3 Right panel
4 External modem (not shipped with every
system)
5 #12 × 1-inch shoulder screws
6 AC power cord (NEMA 5-15P or IEC 320)
7 Processor Interface cable
8 Single-point ground block
9 14-inch (35.5-cm) 6 AWG (#40) (16 mm
2
)
ground wire
10 Flash card (backup)
qrdmprt3 KLC 093002
4
8
9
5
3
2
1
6
7
10