Filter
Top Products
1Install and cable a G600 cabinet
S8100 Installation and Upgrades 57
November 2003
1 Install and cable a G600
cabinet
This chapter describes procedures for installing and cabling the cabinet to physically connect and access
an S8100 Media Server with G600 Media Gateways. Also, for either a G600 or CMC1 Media Gateway,
Section II of this chapter describes procedures for installing telephones and making auxiliary
connections.
NOTE:
A G600 is a rack-mounted cabinet, whereas a CMC1 is a wall- or table-mounted cabinet.
For information about installing a CMC1 cabinet, see Appendix I – Install and cable a
CMC1 cabinet on page 343.
NOTE:
The physical installation of a G600 cabinet is similar to a ProLogix cabinet. The cabling is
also similar, except for the Processor Interface cable (multileg cable). Do not access
applications, such as Communication Manager, until installation and cabling of the
cabinet are finished. Your configuration can consist of an S8100 Media Server with 1, 2,
or 3 G600 Media Gateways.
This chapter is organized as follows:
Section I – S8100 with a G600 installation
on page 58
• Site requirements on page 58
• Check customer’s order on page 59
• Correct shipping errors on page 59
• Unpack and inspect on page 60
• Install and cable a G600 cabinet on page 65
• Check AC power and ground for G600 on page 72
• Cable a G600 system on page 78
• Install G600 patch panels and external modem on page 84
• Install equipment-room hardware for G600 on page 86
• Set ringing option for G600 on page 97