Filter
Top Products
1Install and cable a G600 cabinet
Complete installation
S8100 Installation and Upgrades 137
November 2003
Figure 46: Setting the neon voltage
1 Call a telephone with a neon message indicator and leave a message.
2 Check for ring ping (single ring pulse) each time the lamp flashes (approximately every 3
seconds).
3 Adjust the control clockwise in small increments until the ring ping stops. Ensure that the
message lamp still lights when the adjustment is finished.
Complete installation
1 Disconnect the laptop.
2 Remove the RJ45 connector used to connect the laptop.
3 Insert the flash disk.
4 Set the left and right doors of the CMC1 onto the hinge pins and close the door(s). The doors must
be closed to prevent EMI emissions. Tighten the door screws.
5 For the CMC1, set the right cover panel onto the right panel and secure. Do not use force.
didmt1 KLC 053097