Filter
Top Products
1 Install and cable a G600 cabinet
Set neon voltage to prevent ring ping
136 S8100 Installation and Upgrades
November 2003
The modem is preconfigured to operate correctly. See Modem’s configuration and administration on page
262 for procedures on how to verify that the correct defaults are set, how to configure the modem, and
how to test the modem.
Set neon voltage to prevent ring ping
NOTE:
There is no need to set neon voltage on a G600.
NOTE:
If the ringing option is set to 50 Hz, neon voltage is not available. If 25 Hz is selected, the
maximum voltage is 120 volts. See Set ringing option for CMC1
on page 385.
NOTE:
Set the control to OFF if there are no neon message waiting lamps or if LED message
lamps are used. See Figure 46, Setting the neon voltage,
on page 137.
5 OFF (up) Sets auto answer
6 OFF (up) CD (Carrier Detect) override (modem sends CD signal on connect, drops
CD on disconnect)
7 OFF (up) Power-on and ATZ reset software defaults (loads Y or Y1 configuration
from NVRAM)
8 ON (down) AT (Attention) command set recognition (enables recognition, smart mode)
Table 23: Switch settings for US Robotics external modem, 2 of 2
Switch Setting Function
2 of 2