Filter
Top Products
Checklists and job aids
Upgrade an S8100’s R9.5 software by replacing the S8100
S8100 Installation and Upgrades 27
November 2003
Upgrade steps
Step Details
1 For a direct connection between the
technician’s laptop and the S8100’s service
port:
LT – Change laptop’s IP address to
192.11.13.5
a Right-click the 'Network Neighborhood' {My
Network Places} icon on the laptop’s desktop and
select Properties.
b {Right-click ‘PCMIA Ethernet Connection’ (or Local
Area Connection) and select Properties.}
c Highlight the TCP/IP icon from the popup window
and select Properties. Check the ‘Specify an IP
address’ {‘Use the following IP address’} radio
button.
d Enter 192.11.13.5 in the IP address field and
255.255.255.252 in the subnet mask field, and click
OK to close the popup windows.
2 LT-IE – Disable proxy servers on Internet
Explorer.
a Open Internet Explorer and select Tools, Internet
Options, the Connections tab, and LAN Settings.
b Uncheck the ‘Use a proxy server’ radio button, and
click OK to close the popup windows.
3 Connect the laptop to the R9.5 Processor
board (TN795).
a Connect a cable from the laptop’s PCMCIA Ethernet
card to an RJ45 coupler.
b Connect a cross-over (flip) cable from the coupler to
the PCMCIA network-interface card in the TN795’s
PCMCIA slot.
4 LT – Connect to the TN795 processor. a Click Start, Run, and enter telnet 192.11.13.6.
b Log in using lucent3. – The LAC prompt displays.
5 LAC – Open a bash shell by typing bash at
the LAC prompt.
Type bash at the LAC prompt.
6 BS – Important! – Display and record the
customer’s network and product
information.
a From the bash shell, execute the following three
commands – setip, productid, oss.
b Write down all of this information exactly as it
appears on the screen. You will need to re-enter
this information later.
7 BS – Shutdown AUDIX. Type shutdown audix. When the BASH prompt returns
(the Audix shutdown takes a few minutes), type statapp to
verify that AUDIX has shutdown.
8 BS – Exit the bash shell and return to the
LAC prompt.
Type exit.
9 LAC – Open a SAT window. Type definity to open a SAT window. (The terminal type is
‘NTT’ {‘W2KTT’}.)
10 SAT – Save the DEFINITY translations to
the hard drive and logoff the SAT window.
a Execute save translations.
b When the save translations operation is finished,
execute logoff to logoff the SAT window and return
to the LAC prompt.