Filter
Top Products
J Install and cable a CMC1 cabinet
Install CMC1 main distribution frame (MDF) and external modem
370 S8100 Installation and Upgrades
November 2003
Install CMC1 main distribution frame (MDF) and
external modem
Install the MDF on CMC1
!
WARNING:
The optional MDF is a special 110 cross-connect field that is smaller than the standard 110 cross-
connect hardware. Do not install standard 110 hardware inside the right panel.
NOTE:
The depth of any equipment installed inside the right panel must not exceed 2.5 inches
(6.3 cm), or the right cover panel will not fit over the right panel.
The optional MDF represents the trunk/auxiliary field.
• Mount the optional MDF to the right panel using the following procedure:
Bottom-mounted MDF with modem
1
Behind the MDF, cut the cable tie securing the top 5 cables to the MDF mounting frame.
2 Mount the MDF to the right panel. See Figure 71, Typical bottom-mounted MDF and modem
cable routing, on page 371.
3 Secure all 10 cables to the bottom left bracket on the MDF with a cable tie.