Filter
Top Products
3System initialization
S8100 Installation and Upgrades 159
November 2003
3 System initialization
This chapter describes the procedures needed to initialize the S8100 system.
Starting with Release 10 for S8100, telephony features are activated or deactivated by the license file.
The System Parameters Customer Options form is no longer used to activate/deactivate features – you
can still display this form to see which features are activated, but you cannot use it to turn features on and
off.
This chapter is organized as follows:
• Connectivity and access to the S8100 system on page 160
• Configure DHCP and TFTP servers on page 161
• Preliminary tasks on page 162
• License file, password file, and installation script overview on page 164
• Obtain the license and password files on page 165
• Obtain the installation script file on page 166
• Install the password file, license file, and installation scripts on page 168
• Resolve alarms on page 173
• Check system’s status on page 173
• Place a test call on page 182
• Enable customer logins on page 173
• Administer S8100 on page 174
• Call accounting on page 185
• Administer Communication Manager for INTUITY AUDIX initialization on page 185
• INTUITY AUDIX administration on page 194
• Download Avaya Site Administration on page 197
• Administer SNMP on page 199
• Schedule backups on page 205
This chapter describes administration procedures using the SAT interface. Normally, this interface uses
the function keys F1–F10 on your SAT terminal or PC to perform SAT functions. However, if you are
running Windows 2000 on your PC and are using the W2KTT terminal emulation, you need to use Esc-
key sequences to perform these functions instead of the function keys. The following table shows the
escape-key sequence for each action.