Filter
Top Products
JInstall and cable a CMC1 cabinet
Install CMC1 main distribution frame (MDF) and external modem
S8100 Installation and Upgrades 371
November 2003
Figure 71: Typical bottom-mounted MDF and modem cable routing
Install the external modem
The US Robotics external modem is the recommended external modem. CMC1 systems operate with this
modem set to factory default settings.
NOTE:
You may use a locally obtained, type-approved external modem (33.6 kbps or higher and
V.34 protocol). Contact your Avaya representative for more information.
!
WARNING:
If you use a modem other than the US Robotics modem, it must be configured in Windows.
1 Use the hardware provided with the modem. See Figure 71, Typical bottom-mounted MDF and
modem cable routing, on page 371. If top-mounting MDFs, mount the external modem to the
plywood in a location which allows the standard connection to the modem cable.
2 Route the modem cable (P2) from the Processor Interface cable through the cable trough and to
the modem.
Figure notes
1 Main distribution frame (MDF)
2 External modem
3 Processor Interface cable (connect P2 to modem)
4 #12 × 1-inch shoulder screw
Note: Do not plug anything into slot 1 of Cabinet 1.
cadmrpn4 KLC 051399
2
4
5
5
4
4
3
32
1
1
2
10 9 8 7 6
10 9 8 7 6
3
1
2
5
6
7
8
4
3
9
10
1