Filter
Top Products
Checklists and job aids
Replace an S8100’s hard drive
S8100 Installation and Upgrades 23
November 2003
19 Carefully replace the hard drive on the Processor
board with the new hard drive.
Note: Hard drives are always installed in the top slot of
the drive bay.
20 Re-install the Processor board into the platform
and power up the system.
21 Wait approximately 5 minutes then reconnect to
the S8100’s desktop and open a bash shell.
Repeat steps 3 through 5.
22 BS – Verify the software’s version. Type swversion. Ensure that the Release number and
MultiVantage version number are as expected.
23 SDT – On the S8100’s desktop, double-click the
time display and set the time, time zone, date,
and Daylight Savings.
The time display is in the tool tray at the lower right of
the desktop.
24 SDT – Disable modem compression. a Click Start → Settings → Control Panel.
b Double-click Phone and Modem Options.
c Click the Modems tab.
d Select the installed modem and click Properties.
e Click the Advanced tab.
f Click Change the Default Preferences.
g In the Compression drop-down list, select
Disabled.
h Close each dialog by clicking OK, and close the
Control Panel window.
25 SDT – Open a bash shell window. Click Start → Run → bash.
26 BS – Administer the customer’s parameters that
you wrote down in Step 15
, using the setip
command.
setip name=<args>
setip cust=<args>
setip dns=<args>
setip wins=<args>
setip ras=<args>
Replace each “<args>” with the corresponding parameter
you recorded in Step 15
.
27 BS – Administer the product ID and OSS
parameters using the ‘productid’ and ‘oss’
commands.
productid multivantage-product-id <arg>
productid audix-product-id <arg>
oss <telno> <retries> <retry_interval>
Replace each “<arg>” with the corresponding parameter
you recorded from Step 15
. For the oss command, enter
the <telno>, <retries>, and <retry_interval>
parameters separated by spaces; do not enter commas.
28 BS – Telnet into the LAC window from the
bash.
Execute telnet 127.1, and log in using lucent3.
29 LAC – Install the new license and password file
from the LAC window using the lucent3 login
ID.
For details, see Chapter 3 in Installation and Upgrades
for the Avaya S8100 Media Server with the Avaya G600
and the Avaya CMC1 Media Gateways, 555-233-146.
Step Details