Filter
Top Products
3 System initialization
Manually set S8100’s customer-related information (alternative to ART)
170 S8100 Installation and Upgrades
November 2003
If the serial-number mismatch occurs because of a processor swap out, the serial number of the system’s
processor no longer matches the license file’s serial number:
• Normal call processing continues.
• The system enters license-error mode.
• A major alarm is sent.
• The 6-day countdown timer starts. – Replace the old processor or install a new license file within
6 days.
Manually set S8100’s customer-related information
(alternative to ART)
The installation script downloaded from the ART web site normally configures every system parameter.
Use the procedure in this section only if the customer has a maintenance contract and an installation
script’s file was not installed in the previous procedure, Install the password file, license file, and
installation scripts on page 168.
NOTE:
Rebooting is required for these changes to take effect. To avoid multiple rebooting, set
every customer-related parameter and license file installation before rebooting the system.
The customer-related parameters configured by this procedure are: 1) RAS IP address, 2) product ID
(definity and audix), 3) alarm-destination number, and 4) alarm origination.
Manually setting RAS IP address:
To connect the system to the modem, you need to get the RAS IP address from the registration group at
the time of License file generation. The recommended procedure is:
1 Telnet to the S8100 from the laptop.
2 Go to the "bash" shell from LAC by typing "bash".
3 Use the “setip” command to set the IP addresses. The format is:
setip ras=<RAS IP Address> (for example, setip ras=198.152.30.15)
This completes the procedure to set the RAS IP addresses.
Instead of using the setip command, you could use the following alternative procedure:
Connect to the S8100 through the web interface. This is done by typing http://192.11.13.6 on the Internet
Explorer with proxy server turned OFF. Login as "lucent3" and password "lucent3".
4 Go to the Administer system, which pops up the Screen to administer the system. Select the
Terminal server option on the screen. (If you receive error messages when starting a Terminal
Server session, click OK for each error message.) Login as "lucent3" and password "lucent3".
5 Select the Network Connections on the S8100 desktop and change the IP address on the incoming
connections with the RAS IP address.