Filter
Top Products
Checklists and job aids
Replace an S8100’s hard drive
22 S8100 Installation and Upgrades
November 2003
11 SDT-IE – Backup everything to the PCMCIA
card or to a network location.
Note: If the medium you are backing up to runs
out of space, a message will appear noting the
files that were not backed up. In this case, find a
different backup location or PCMCIA card with
enough capacity and rerun the entire backup.
a Click 'Administer System'
b Log in with lucent3.
c Click ‘Backup & Restore’ under System
Maintenance.
d Click ‘Immediate Backup’.
e Under “Choose Items for Immediate Backup,”
select everything that is installed.
Note: If the S8100’s internal AUDIX is being used, you
must do two backups. First, select the “AUDIX
translations, names & messages” radio button in addition
to “MultiVantage announcements” and “MultiVantage
translations.” When the backup finishes, return to the
‘Immediate Backup’ screen and select only the “AUDIX
announcements” radio button and send this backup to the
same or a different location.
f Set Destination to PCMCIA or click ‘Other
Location’ to send the backup to a network
location
g Click the Backup button.
12 SDT-IE – Record AUDIX extension length.
Note: You will need to verify the extension
length later.
a Click the Back icon (on the IE tool bar) twice to
return to the Administer System page.
b From the explorer window, click 'Default AUDIX
Settings'.
c Note whether AUDIX is enabled. If so, click
‘AUDIX Extension Length’ and record the
extension length.
13 SDT-IE – Close Internet Explorer on the
S8100’s desktop.
14 SDT – Open a bash shell window (if not already
open).
Click Start → Run → bash.
15 BS – Important! – Display and record the
customer’s network and product information.
a From the bash shell, execute the following three
commands – setip, productid, oss.
b Write down all of this information exactly
as it appears on the screen. You will need to
re-enter this information later.
16 BS – From the bash shell, execute shutdown
system.
17 The green “Complete” LED on the S8100’s
faceplate will be flashing during the shutdown
process. Wait until this LED is on steady. Then
power down the system.
18 Disconnect the cross-over cable from the
Processor board and remove the board from the
cabinet.
Step Details