Filter
Top Products
KIdentify a hard disk for PCN1413b
S8100 Installation and Upgrades 389
November 2003
8 Open a CMD (Command) window on your laptop:
a Click Start → Run, and then type cmd in the Run dialog.
b Click the OK button.
9 Using the S8100 system’s IP address, Telnet to and log into the system.
NOTE:
Depending on your specific login credentials, the system returns either the LAC or BASH
prompt.
10 Access the bash shell (if necessary), and use it for the rest of this procedure.
11 At the BASH prompt, enter ftpserv to start the FTP service.
12 Open another CMD (Command) window on your laptop. (For details, refer to Step 8.)
13 Enter ftp -A [IP Address] to open an FTP session with the S8100.
14 At the ftp> prompt, transfer the diskcheck file to the S8100:
a Enter bin to set up a binary transfer.
b Type mput diskcheck, and then type "y" to execute the transfer.
15 When the transfer finishes, enter bye to exit the FTP service.
16 Access the S8100’s diskcheck utility:
a At your laptop, reopen (toggle back to) the other CMD window.
a Enter cd //d/lucentpub/ftproot.
b Enter pwd to verify the S8100’s current directory.
17 Enter ./diskcheck to verify whether the hard drive needs to be replaced. If so, the utility returns a
message similar to:
REPLACE 2 IBM-DJSA-220
Once the new drive is acquired, continue with Replace an S8100’s hard drive
on page 20.