Filter
Top Products
Checklists and job aids
Initial installation
S8100 Installation and Upgrades 7
November 2003
11 Set ringing option. See Set ringing option for G600 on page 97
or
See Set ringing option for CMC1
on page 385.
12 Install and wire telephones and other equipment.
— Install attendant console. (optional)
— Install 26B1 Console. (optional)
See Install and wire telephones and other
equipment on page 99.
13 Connect external alarms and auxiliary connections. See Connect external alarms and auxiliary
connections on page 113.
14 Install the BRI terminating resistor. See Install the BRI terminating resistor on page
116.
15 Use multipoint adapters to provide signal fanout of
the T-interface.
See Install multipoint adapters on page 119.
16 Wire the off-premises stations with the cabling
provided by the local telephone company.
See Install off-premises station wiring on page 122.
17 Install the emergency-transfer panel (or equivalent)
and associated analog telephones to enable
emergency transfer.
See Install emergency-transfer panel and associated
telephones on page 127.
18 Connect modem. See Connect modem to telephone network on page
134 and Connect modem
on page 135.
19 Set the neon voltage for S8100/CMC1, only if the
ringing option is set to 25 Hz.
(There is no need to do this for S8100/G600.)
See Set neon voltage to prevent ring ping on page
136.
20 Finish the installation. See Complete installation on page 137.
Installation tasks For more information