Filter
Top Products
JInstall and cable a CMC1 cabinet
Install equipment-room hardware for CMC1
S8100 Installation and Upgrades 377
November 2003
Circuit pack installation
!
WARNING:
When handling circuit packs or any components of a CMC1, always wear an authorized wrist
ground strap. Connect the strap to the ground connector provided on the system’s cabinet.
Circuit-pack slot loading
Every circuit-pack slot in the CMC1 is a “universal slot.” Any slot can contain any type of port circuit
pack, with the following exceptions for Cabinet A.
1 Install the TN2314 Processor circuit pack in slot 2. See Figure 72, CMC1 cabinet and slot
numbering, on page 378.
2 Install the required TN744E Call Classifier/Tone Detector circuit pack in slot 3.
3 Load a port circuit pack in every other slot. See Table 63, Circuit-pack installation order
(loading), on page 378 for the recommended circuit-pack layout.