Filter
Top Products
Checklists and job aids
Replace an S8100’s hard drive
S8100 Installation and Upgrades 21
November 2003
2 LT-IE – Disable proxy servers on Internet
Explorer.
a Open Internet Explorer and select Tools, Internet
Options, the Connections tab, and LAN Settings.
b Uncheck the ‘Use a proxy server’ radio button
and click OK to close the popup windows.
3 Connect the laptop to the service jack on the
front of the S8100’s Processor board.
a Connect a cable from the laptop’s PCMCIA
Ethernet card to an RJ45 coupler.
b Connect a cross-over (flip) cable from the coupler
to the TN2314’s RJ45 jack.
4 LT-IE – Connect to the S8100 server via the web
interface.
Open Internet Explorer on the laptop and enter
192.11.13.6 in the URL address bar to connect to the
processor.
5 LT-IE – Open the S8100’s desktop.
Note: Terminal server client and terminal
services Active X must be installed on the
laptop. The easiest way to do this is to upgrade
your Windows 95 laptop’s browser to Internet
Explorer 5.5.
a Click ‘Administer System’ and log in using
lucent3 for log-in ID and password. A domain is
not required. Select 'continue' at license
agreement window.
b Select ‘Login to 192’ under Remote Control –
Terminal Services.
c If a VBScript error message appears, click OK.
d Click the Connect button (leave the Server field
blank).
e If a VBScript message appears, click OK (you
can resize the Terminal Services screen to full
size by pressing ctlr-alt-Pause). A log-in window
will open.
f Log in using lucent3. After logging in, the
S8100’s Windows 2000 desktop is displayed.
6 SDT – Open a bash shell window. Click Start → Run → bash.
7 BS – Open a LAC window. Execute telnet 127.1,.and log in using lucent3.
8 LAC – Open a SAT window and execute save
translations.
Type multivantage to open a SAT window. (The
terminal type is W2KTT.)
9 LAC – Return to the bash window. a Type logoff to log out of the SAT window.
b Press Enter, and type exit to exit the LAC
window.
c Close the LAC window.
Note: Do not close the LAC window until you have
issued the 'exit' command.
10 SDT – Open Internet Explorer on the S8100’s
desktop and log in using lucent3.
Note: This step could be done by closing the S8100’s
desktop and using the laptop’s IE session, but then you
would need to set up a new S8100-desktop session for the
subsequent steps.
Step Details