Filter
Top Products
J Install and cable a CMC1 cabinet
Install an S8100 with a CMC1 system cabinet
350 S8100 Installation and Upgrades
November 2003
Floor mount the CMC1 cabinet
The dimensions of each cabinet (with floor pedestal) are 28.5 inches (72.4 cm) high × 24.5 inches
(62.2 cm) wide × 12 inches (30.5 cm) deep. Maintain a service clearance of 12 inches (30.5 cm) on the
left, right, and front of the cabinet. If your configuration requires 2 cabinets, be sure each maintains the
service clearance of 12 inches (30.5 cm) on the left, right, and front sides.
To floor mount the cabinet:
1 Floor mount the cabinet as shown in Figure 56, Typical floor-mounted installation, on page 350.
Figure 56: Typical floor-mounted installation
2 Proceed to Check AC power and ground for CMC1 on page 357.
Wall mount the CMC1 cabinets
!
DANGER:
A fully loaded system with a single CMC1 cabinet weighs 58 lbs (26.3 kg). Use lifting
precautions. The CMC1 unit weighs 29 lbs (13.1 kg) with the doors, power unit, and
circuit packs removed.
Figure notes
1 Left panel (floor-mounting pedestal)
2 #12 × 1-inch shoulder screws
3 12 inches (30.5 cm) minimum from nearest
object (required to service the circuit packs)
indmflor KLC 083002
1
2
3