Filter
Top Products
1Install and cable a G600 cabinet
Install equipment-room hardware for G600
S8100 Installation and Upgrades 91
November 2003
Circuit-pack installation
!
WARNING:
When handling a circuit pack or any component of a G600 system, always wear an authorized wrist
ground strap. Connect the strap to the ground connector provided on the system’s cabinet.
Circuit-pack slot loading
1
Check the reinstalled circuit packs. Every circuit-pack slot in the G600 is a “universal slot.” Any
slot can contain any type of port circuit pack with the following exceptions for Cabinet A. See
Figure 18, G600 cabinet and slot numbering,
on page 91.
• TN2314 Processor circuit pack must be installed in slot 2 of Cabinet A.
• TN744E Call Classifier/Tone Detector circuit pack should be installed in slot 3.
2 Load every port circuit pack. See Table 7, Circuit-pack installation order (loading), on page 91 for
the recommended circuit-pack layout.
Figure 18: G600 cabinet and slot numbering
.
Table 7: Circuit-pack installation order (loading) 1 of 2
Function Apparatus code Load G600 from Notes
Processor TN2314 Slots 1 and 2
Call Classifier/Tone
Detector
TN744E Slot 3
Announcement TN750C Any slot
Speech Synthesizer TN725B Any slot
Control C-LAN TN799DP Left
1 of 2
101 2 3 4 5 6 7 8 9
Power
BBI
LINK
TRMT
RCV
100bT
LINK
TRMT
RCV
scdpff03 KLC 082002
Do Not Remove Board Unitl
Shutdown Is Com
plete
On
Auto
Off
In Use
Do Not Remo
ve
Maj Alarm
Min Alarm
Clock
Service
Access
Emergency
Transfer
Complete
Shutdown
Do Not Remove W
hen In Use