Filter
Top Products
1 Install and cable a G600 cabinet
Unpack and inspect
64 S8100 Installation and Upgrades
November 2003
106606536 Integrated channel-service unit (ICSU) (120A2) ×
107988867 DS1 loop-back jack (T1 Only) (700A) ×
848477634 Cross-over cable ×
107152969 75-Ohm DS1 coaxial adapter (888B) ×
403613003 157B connecting block (“sneak-current protectors”) ×
406948976 6SCP-110 protector ×
107435091 507B sneak-current fuse panel ×
407216316 220029 sneak-current fuse ×
104307327 C6C cable – 50-foot (15.2-m) shielded DS1 cable with 50-pin male to
15-pin male
×
104307376 C6D cable – 50-foot (15.2-m) shielded DS1 cable with 50-pin male on
each end
×
104307434 C6E cable – 100-foot (30.5-m) shielded DS1 cable with 50-pin male to
50-pin female
×
104307475 C6F cable – 50-foot (15.2-m) shielded DS1 cable with 50-pin male to
3-inch (7.62-cm) stub
×
102381779 3B1A carbon block ×
104410147 3B1E-W wide-gap gas tube ×
105514756 3C1S analog-line protector – solid state ×
102904893 4B1C carbon block with heat coil ×
104401856 4B1E-W wide-gap gas tube with heat coil ×
104386545 4C1S analog-line protector – solid state with heat coil ×
105581086 4C3S-75 digital voice-circuit protector – solid state ×
406144907 ITW Linx gas tube, avalanche suppress ×
901007120 ITW Linx ground bar (used with above) ×
406304816 ITW Linx replacement fuse ×
103972758 Data-link protector (1 circuit) ×
103972733 Data-link protector (8 circuits) ×
407063478 Electrostatic discharge (ESD) wrist strap
407691401 Z3A2 alarm adapter (required with UPS) ×
Table 3: Comcodes for equipment used with G600 2 of 2
Comcode Description Optional
2 of 2