Filter
Top Products
3 - 92
3 Setup
MITSUBISHI CNC
【#3106】 zrn_typ Zero point return specifications
Select the zero point return specification.
Functions are allocated to each bit.
Set this in hexadecimal format.
bit F : Spindle zero point detection with contactless switch
0: Normal 1: Enable spindle zero point detection using proximity switch
bit E : Interpolation mode selection in orientation
0: Interpolation mode (Use the interpolation mode gain "SP002 PGN".)
1: Non-interpolation mode (Use the non-interpolation mode gain "SP001 PGV")
Select this when vibration occurs since the gain is too high during the orientation.
bit D-B :
Not used. Set to "0".
bit A-9 : Spindle/C axis zero point return direction
bitA,9=
00: Short-cut
01: Forward run
10: Reverse run
bit 8 : Designate zero point return/deceleration stop of spindle/C axis
0: Zero point return 1: Deceleration stop
bit 7 : Synchronous tapping command polarity
0: Forward direction 1: Reverse direction
bit 6-5 : Synchronous tapping zero point return direction
bit 6,5=
00: Short-cut
01: Forward run
10: Reverse run
bit 4 : Designate zero point return/deceleration stop in synchronous tapping
0: Zero point return 1: Deceleration stop
bit 3 :
Not used. Set to "0".
bit 2-1 : Orientation direction
bit 2,1=
00: Short-cut
01: Forward run
10: Reverse run
bit 0 : Z phase detection direction
0: Forward direction 1: Reverse direction
Interpolation mode selection in orientation
Z phase detection direction
Orientation direction
Synchronous tapping zero point return/Deceleration stop designation
Synchronous tapping zero point return direction
Synchronous tapping command polarity
Spindle/C axis zero point return/Deceleration stop designation
Spindle/C axis zero point return direction
Spindle zero point proximity switch detection