Filter
Top Products
5 - 48
5 Spindle Adjustment
MITSUBISHI CNC
bitE. In spindle holding force up (TLUP)
It indicates that spindle holding force up (disturbance observer) is in running at TLUA=1.
bitF. In 2nd in-position (INP2)
The status changes to INP2=1 when position droop exists within the in-position area set by
parameter SP025 (INP2) regardless of serve ON or OFF.
(Note) The bits other than those above are used for maintenance.
(6) Spindle control output 6
This is used for maintenance.