Filter
Top Products
Appendix 2 - 2
Appendix 2 Cable and Connector Assembly
MITSUBISHI CNC
Appendix 2-1 CM10-SPxxS-x(D6) plug connector
This section explains how to assemble the wire to CM10 plug connector.
(1) Cutting a cable
Cut the cable to the following dimensions:
(Note) Not to change cable length.
Cable length after cutting = 35±0.5mm for CM10-SPxxS-x(D6) + Cable length
= 35±0.5mm + Cable length
(2) Inserting parts
Insert the clamp nut, the cable clamp, the bushing and the back shell to the cable.
(Note) Pay attention to the direction each part is inserted.
Make sure that every part is inserted.
(3) Stripping a cable
Strip the cable’s sheath to the A length, cut the wire set at its root and strip the core wire to the B length.
(Note) Make sure to strip the cable to the correct length.
Do not leave cutting or scratch to the cable core.
* When making CM10-SP10S-x(D6), strip the cable for No. 10 terminal in a way that the A length
becomes 1mm longer than that of other cables.
(This is to prevent excessive tension of the cable when inserting the contact to the housing in
the next process.)
Product name A [mm] B [mm]
CM10-SP10S-x(D6) 18.5 to 19.5
4.5 to 5.0
CM10-SP2S-x(D6) 17.5 to 18.5
Cable length
Cable
Cable clamp
Bushing
Back shell
Clamp nut
A
B
Sheath
Core wire
(A+1mm for No. 10 terminal only)
Cable core