Filter
Top Products
7 - 10
7 Maintenance
MITSUBISHI CNC
7-3-2 Replacing the unit fan
(1) Replacing parts
Unit fan type
(2) Replacement procedure
Replace the unit fan with the following procedures.
<MDS-D-SVJ3-07NA, MDS-D-SPJ3-075NA>
Drive unit type Fan type Size [mm]
MDS-D-SVJ3-07NA,
MDS-D-SPJ3-075NA
MMF-04C24DS BKO-CB0479H01 40SQ.
MDS-D-SPJ3-110NA MMF-06F24ES-RP1 BKO-CA1638H01
60SQ.
MDS-D-SVJ3-10NA/20NA/35NA,
MDS-D-SPJ3-22NA/37NA
MMF-06F24ES-RP3 BKO-CB0500H01
MDS-D-SPJ3-55NA/75NA MMF-08G24ES-CP1 BKO-CA1941H01 80SQ.
㪮
䌗䌁䌒䌎䌉䌎䌇䌗䌁䌒䌎䌉䌎䌇
䌃䌁䌕䌔䌉䌏䌎䌃䌁䌕䌔䌉䌏䌎
㪚㪟㪘㪩㪞㪜㪚㪟㪘㪩㪞㪜
㪚
㪬
㪭
㪛
㪣㪈㪈㪣㪈㪈
㪣㪉㪈㪣㪉㪈
㪧㪈㪧㪈
㪧㪉㪧㪉
㪣㪊㪣㪊
䌃䌎㪐䌃䌎㪐㪚㪥㪈㪘㪚㪥㪈㪘㪚㪥㪈㪙㪚㪥㪈㪙㪚㪥㪉㪚㪥㪉䌃䌎㪊䌃䌎㪊
䌂䌁䌔䌂䌁䌔
㪣㪈㪣㪈
㪣㪉㪣㪉
䌍䌉䌔䌓䌕䌂䌉䌓䌈䌉䌍䌉䌔䌓䌕䌂䌉䌓䌈䌉
㪧㪂㪧㪂
㪥㪄㪥㪄
Open the fan guard.
Pull out in a diagonal direction
and remove it from the latch.
Direction of
the fan wind
Remove the mounting screws.
Disconnect the connection connector of
the fan mounted on the unit side face.
Connecting the lead wires of fan,
insert it between the chassis’ s protrusion
and the fan as shown above.