Filter
Top Products
1 - 26
1 Installation
MITSUBISHI CNC
(2) Setting the parameters
The parameters related to the installation accuracy diagnosis for PLG detector are shown below.
【#13018(PR)】 SP018 SPEC2 Spindle specification 2
bit 1 : oplp Open loop
0: Disable 1: Enable
【#13113】 SP113 OPLP Current command value for open loop
Set the current command value for when the open loop control is enabled.
When "0" is set, the state will be the same as when "50" is set.
When not using, set to "0".
The open loop control is enabled when "SP018 (SPEC2)/bit1 (oplp)" is set to "1".
---Setting range---
0 to 999 (Short-time rated %)