Filter
Top Products
7 - 15
MDS-D-SVJ3/SPJ3 Series Instruction Manual
7-3 Adding and replacing units and parts
(2) Replacement procedure
Replace the battery with the following procedures.
<Replacement procedure for the cell battery MR-J3BAT>
[1] Turn the breaker for the input power OFF. Make sure the power of the replacing drive unit is turned
OFF.
[2] Pull out the battery connector connected with the connector BAT of the drive unit.
[3] Slide the battery and remove it while holding the tab on the battery side face.
[4] Connect a new battery connector to the connector BAT of the drive unit.
[5] Install the battery into the drive unit.
1. The power of the drive unit must be turned ON for 30min. or longer before replacing the battery.
2. Replace the battery within one hour.
CAUTION
Remove
Install
Insert the cable end connector of
the battery into the BAT terminal of
the drive unit.