Filter
Top Products
5 - 7
MDS-D-SVJ3/SPJ3 Series Instruction Manual
5-2 Adjustment procedures for each control
5-2 Adjustment procedures for each control
5-2-1 Basic adjustments
(1) Items to check during trial operation
[1] When the power is ON for the first time, check the wiring. When the machine is operated for the first
time, check the set parameters again.
[2] Confirm that the values of the NC side parameters "slimt1 to 4", "smax1 to 4", and "smini" comply
with the machine specification.
[3] When the machine running-in has not been completed, gradually raise the rotation speed (in
increments of 1000r/min) for the spindle. Raise the speed at the timing when the load meter value
is stabilized during rotation.
If the load meter value is higher than the normal value, stop the operation and check the spindle
section of the machine.
[4] Confirm that the command (S command) speed and actual speed match during running-in. When
gear ratio is set, the spindle end speed and motor speed differ.
[5] Confirm that there is no abnormal noise, odor or motor overheat during running-in.
(2) Adjusting the spindle rotation speed
When the spindle motor and the spindle end are coupled using a gear or pulley, the rotation speeds of
the spindle motor and the spindle end may not match. Adjust the command and the rotation speed of
spindle end with the following method.
Apply the following adjustment methods [1] to [3] individually to each of the gears 00 to 11. Confirm that
the machine's gear changes correctly before the adjustment.
[1] Set the spindle specification parameters, "slimt1 to 4".
Calculation expression:
slimt1 to 4 = SP026 × (deceleration rate of the gears 00 to 11 between the motor and spindle end)
[2] Set the S command to half of the maximum spindle rotation speed and confirm the rotation speed
of the spindle end. Adjust slimt1 to 4 until the rotation speed matches.
[3] Set the S command to the maximum spindle end rotation speed and confirm that the S command
speed and the spindle end speed match.
1. Do not adjust when possible risks associated with adjustment procedures are not thoroughly taken
into consideration.
2. Be careful when touching rotating section, or your hand may be caught in or cut.
3. Changing of parameters has to be done carefully.
CAUTION