Filter
Top Products
2 Wiring and Connection
MITSUBISHI CNC
2 - 24
2-5-2 Connection of the full-closed loop system
Refer to the section "2-4-1 Connecting the servomotor" for details on connecting each motor type and wiring
the power line or the motor magnetic brake.
(1) Connecting the ball screw side detector
Connect the ball screw side detector cable to CN3. Option battery is required for the absolute position
system.
(2) Connecting the linear scale (For Mitsubishi serial signal output)
Mitsubishi serial signal output (including when SIN wave signal output is converted to Mitsubishi serial
signal output with a scale manufacturer detector interface unit) can directly input to the drive unit.
CN3
CN2
MDS-D-SVJ3
LG
RQ*
SD*
2
4
6
8
10
P5 (+5V)
RQ
SD
BT
1
3
5
7
9
NamePin
NamePin
No.1 No.9
Pin No.
No.2 No.10
Detector connector CN3
CNV2E cable
Max. 30m
CNV2E cable
Max. 30m
Detector type setting
SV025 62xx
Servomotor
Ball screw side
detector
CN3
CN2
MDS-D-SVJ3
1
3
5
7
9
P5(+5V)
RQ
SD
LG
RQ*
SD*
2
4
6
8
10
No.1 No.9
No.2 No.10
Cable prepared by user
Max. 30m
Linear scale
( Mitsubishi serial signal output )
(Note) The conversion unit of the scale manufacturer is included.
Detector type setting
SV025 A2xx
CNV2E cable
Max. 30m
Servomotor
Pin No.
Detector connector CN3
Name
Name
Pin Pin