Filter
Top Products
2 Wiring and Connection
MITSUBISHI CNC
2 - 12
(2) MDS-D-SVJ3-10NA/20NA, MDS-D-SPJ3-22NA
(a) Drive unit power supply connectors
(b) Termination of the cables
[1] CNP1, CNP3
Solid wire: After the sheath has been stripped, the cable can be used as it is.
Twisted wire: Use the cable after stripping the sheath and not twisting the core. At this time, take
care to avoid a short caused by the loose wires of the core and the adjacent pole.
Do not solder the core as it may cause a contact fault. Alternatively, a bar terminal
may be used to put the wires together.
[2] CNP2
Solid wire: After the sheath has been stripped, the cable can be used as it is.
Twisted wire: Use the cable after stripping the sheath and not twisting the core. At this time, take
care to avoid a short caused by the loose wires of the core and the adjacent pole.
Do not solder the core as it may cause a contact fault. Alternatively, a bar terminal
may be used to put the wires together.
CNP3
CNP1
CNP2
06JFAT-SAXGFS-XL
03JFAT-SAXGFS-XL
05JFAT-SAXGSA-E-SS
Drive unit
Connector for CNP1
(J.S.T.)
Connector for CNP2
Connector for CNP3
<Applicable cable example>
Ǿ
3.8mm
Cable finish OD: to
<Applicable cable example>
Ǿ
5mm
Cable finish OD: to
(J.S.T.)
(J.S.T.)
7mm
Core
Sheath
8 to 9mm
Core
Sheath