Filter
Top Products
5 - 46
5 Spindle Adjustment
MITSUBISHI CNC
(4) Spindle control output 4
bit0. In spindle control mode selection 1 (SC1)
bit1. In spindle control mode selection 2 (SC2)
bit2. In spindle control mode selection 3 (SC3)
These are the answer outputs for control mode selection command 1, 2, 3 (SC1, SC2, SC3).
bit4. In gear changeover command (GKC)
[1] This is an answerer output for the gear changeover command.
[2] The position feedback is generated from the speed detector at GKC=1.
bit5. In gear selection 1 (GR1)
bit6. In gear selection 2 (GR2)
These are the answer outputs for gear selection command 1 and 2 (GR1 and GR2).
(Note) The bits other than those above are used for maintenance.
FEDCBA9876543210
bit
0
1
2
3
4
5
6
7
8
9
A
B
C
D
E
F
-
-
-
-
-
-
-
SC2
GKCGR2
-
-
GR1
SC3 SC1
SC2
GKC
GR2
GR1
SC3
SC1
-
Details
Name Details
Spindle control output 4
In spindle control mode selection 1
(For maintenance)
In gear selection 1
(For maintenance)
(For maintenance)
(For maintenance)
(For maintenance)
In gear changeover command
In spindle control mode selection 2
In spindle control mode selection 3
In gear selection 2
(For maintenance)
(For maintenance)
(For maintenance)
(For maintenance)
(For maintenance)