Filter
Top Products
Appendix 2 - 4
Appendix 2 Cable and Connector Assembly
MITSUBISHI CNC
(5) Inserting the contact
Insert the contact into the specified terminal number point in the housing.
(Insert grounding wire or drain wire into terminal No. 10).
* When the contact catches the housing, you will hear a snap.
* Pulling the wire for confirming the correct position.
(Note) Before inserting the contact, check that the clamp nut, cable clamp, bushing and back shell is
inserted.
Take care not to insert the contact upside down as shown below.
* Insert the contact so that the terminal
number face the same direction.
However, in case of CM10-SP2S-
x(D6), insert the contact so that the
lance and the terminal number face the
opposite direction.
* Using a pull out tool for pulling up
inserted contact.
Tool No.: 357J-50548T
Refer to the instruction manual in case
of using pull up tool.
* As Lance falls down easily after pulling
up, set up to original position before re-
insert.
Cable
Housing
Contact
Terminal No.10 only
(Grounding wire or drain wire)
Insert
Terminal number
Lance
Contact
Terminal number
Lance
Contact
CM10-SP2S
CM10-SP10S