Filter
Top Products
3 - 109
MDS-D-SVJ3/SPJ3 Series Instruction Manual
3-3 Setting the initial parameters for the spindle drive unit
bit 3-1 : nfd1 Depth of Notch filter 1
Set the depth of Notch filter 1.
bit3,2,1=
000: -∞
001: -18.1[dB]
010: -12.0[dB]
011: -8.5[dB]
100: -6.0[dB]
101: -4.1[dB]
110: -2.5[dB]
111: -1.2[dB]
bit 0 : zck Z phase check (ALM42)
0: Enable 1: Disable
【#13035(PR)】 SP035 SFNC3 Spindle function 3
Select the spindle function.
A function is allocated to each bit.
Set this in hexadecimal format.
bit F-D :
Not used. Set to "0".
bit C : shgn SHG control
0: Stop 1: Start
bit B :
Not used. Set to "0".
bit A : pyn Excitation rate selection
0: Select Excitation rate 1 1: Select Excitation rate 2
bit 9 : vgn Speed loop gain set selection
0: Select Set 1 1: Select Set 2
bit 8 :
Not used. Set to "0".
bit 7 :
Not used. Set to "0".
bit 6-3 :
Not used. Set to "0".
bit 2 : pyin Excitation rate selection
The excitation rate after the in-position can be selected.
0: Select Excitation rate 1 1: Select Excitation rate 2
bit 1 : vgin Speed loop gain set selection
The speed loop gain set after the in-position can be selected.
0: Select Set 1 1: Select Set 2
bit 0 :
Not used. Set to "0".