3 - 121
MDS-D-SVJ3/SPJ3 Series Instruction Manual
3-3 Setting the initial parameters for the spindle drive unit
【#13099】 SP099
Not used. Set to "0".
【#13100】 SP100
Not used. Set to "0".
【#13101】 SP101
Not used. Set to "0".
【#13102】 SP102
Not used. Set to "0".
【#13103】 SP103
Not used. Set to "0".
【#13104】 SP104
Not used. Set to "0".
【#13105】 SP105
Not used. Set to "0".
【#13106】 SP106
Not used. Set to "0".
【#13107】 SP107
Not used. Set to "0".
【#13108】 SP108
Not used. Set to "0".
【#13109】 SP109
Not used. Set to "0".
【#13110】 SP110
Not used. Set to "0".
【#13111】 SP111
Not used. Set to "0".
【#13112】 SP112
Not used. Set to "0".
【#13113】 SP113 OPLP Current command value for open loop
Set the current command value for when the open loop control is enabled.
When "0" is set, the state will be the same as when "50" is set.
When not using, set to "0".
The open loop control is enabled when "SP018 (SPEC2)/bit1 (oplp)" is set to "1".
---Setting range---
0 to 999 (Short-time rated %)